Renkforce A610 Bedienungsanleitung Seite 55

All manuals and user guides at all-guides.com
Additionally select a scan rate in "Test range" that controls the
frequency of the measured value recording (e.g. 1 minute = one
measured value is saved every minute). The values named as
examples here will cause your recording to record all values for
the range between 20 °C and 22 °C at a scan rate (repetition of
saving of the measured values) of one minute (= 60 measured
values per hour) for the setting "Temp". If you have chosen "Time",
a permanent measurement is performed in the indicated duration
(e.g. 1 hour and 30 minutes).
You can select the number (max. five) of the adjustable "Sections"
under "Testing the interval settings". Here, you can set different
scan rates for the measured values for up to five different tempera-
ture ranges (or time ranges). The lower the interval under "Test
range" is set, the more often will the measured temperature be
updated and saved.
Example:
If you set a temperature of 20 °C to 22 °C and a scan rate of one
minute in the first "Section", the measured temperature value is
saved in a table every minute with the value measured at that time,
independently of the set temperature range of 20 °C to 22 °C.
This is done at this rhythm until the measured value recording is
stopped. The set temperature values (here: 20 °C to 22 °C) have
purely statistical value in this case.
46
If only one "Section" is set up as "Temp", the set scan
rate will not change when the temperature section (here:
20 °C to 22 °C) is exceeded or undercut, and, e.g. (here:
one minute) remain at one minute. For a "Section" set
as "Time", the scan rate will remain the same for the set
duration.