Kinderkraft XPEDITION Bedienungsanleitung Seite 58

• Grasp the car seat and check that it is securely fastened with no slack. If it moves and the
ISOFIX attachments do not extend, repeat the previous steps, check that both ISOFIX
indicators are completely green.
• Press the adjustment buckle release key (fig. A.11) to adapt length of upper fixing belt. The
length of the belt must allow putting the hook on the fixing point at the back of the car seat.
• Put the belt fixing hook on the car fixing point, as recommended in the car manual.
• To finish with, tighten Top tether upper fixing belt until you can see a green indicator (fig.
A.12). The belt must go under the headrest from the car seat.
• Put the child in the safety seat and adjust the headrest to child's height (see point 4.1).
NOTE: Make sure the position of the child safety seat is fixed and stable. Check Top tether
upper fixing and make sure the fixing belt has been properly carried.
• Secure the child in the child safety seat as per points 4.3 and 4.4.
5.3 How to install the child safety seat in a forward-facing position, for children from II/III
weight groups (15-kg-25kg) with the use of 3-point car seat belts and additional lower
ISOFIX fasteners.
IMPORTANT! The car manual shows location of fixing points and other important information
on installation of the child safety seat in the car. The user MUST read the car manual.
• In order to adapt the child safety seat to weight group II/III (15kg-36kg), before installation
please hide 5-point safety belts of the child safety seat, follow the point 6.0.
• Before installing the child safety seat, remove the guard from ISOFIX fasteners (unless
removed beforehand). To do so, slide ISOFIX release key (16), the system will release the
guard which must be removed (fig. A.2.1, A.2.2).
• Place the child safety seat on the car seat, near the backrest.
• Please slide ISOFIX fasteners (5) to their maximum length by unlocking the sliding lever (16)
(fig. A.3, A.3.1). This operation must be performed on both sides of the safety seat.
• Attach ISOFIX guides to the seat connectors (fig. A.4a)
• Protruding ISOFIX fasteners must be connected to elements in the car until you can hear a
distinctive click (fig. A.4b). When ISOFIX installation is correct, the indicator on the button (15)
will turn from red to green. Verify the correct installation, make sure indicators are green (fig.
A.5).
•NOTE! Locking fasteners are correctly fixed only when both button indicators are fully green.
• When the child safety seat is properly installed with the use of ISOFIX fasteners (5), set it in
a forward-facing position. Press the seat rotation lever (12) (fig. A.6), to rotate the child safety
seat in a forward-facing position (fig. A.7.1). The position is correctly secured when you can
see a green color by the seat rotation lever (12).
• After you have completed operations related to child safety seat direction, set the safety
seat backrest inclination. To do so, hold the seat inclination lever (11) (fig. A.8). The child
safety seat must be set in any position from „1" to „4" (fig. A.9.1).
• Such child safety seat must be pushed against the car seat by pressing on both sides of the
child safety seat towards the backrest so that the safety seat adheres to the car seat backrest
as much as possible (fig. A.10.2). After sliding the car seat for a child against the back seat,
58