Kinderkraft XPEDITION Bedienungsanleitung Seite 57

• To finish with, pull Top tether upper fixing belt, make sure the indicator turns green (fig.
A.12). The belt must go under the car seat headrest.
NOTE: Make sure the child safety seat position is correct and stable. Check Top tether upper
fixing and make sure the fixing belt has been properly carried.
• Secure the child in the safety seat as showed in point 4.3 and 4.4.
5.2 How to install the child safety seat in a forward-facing position, for children from I
weight group (9kg-18-kg) in ISOFIX fixing system and Top tether upper fixing belt.
IMPORTANT! The car manual shows location of ISOFIX fixing points and upper fixing belt as
well as other important information on assembly of child safety seat in the car.
The user MUST read the vehicle manual.
• Before installing the child safety seat, please remove the guard on ISOFIX fasteners (if not
removed beforehand). To do so, slide ISOFIX release key (15), the system will release the
guard which must be removed (fig. A.2.1, A.2.2).
• The child safety seat must be placed on the car seat near the backrest.
• Please slide ISOFIX fasteners (5) to their maximum length by unlocking and holding the
sliding lever (16) (fig. A.3, A.3.1). The operation must be performed on both sides of the safety
seat.
• Attach ISOFIX guides to the seat connectors (fig. A.4a)
• Protruding ISOFIX fasteners must be connected to elements in the car until you can hear a
distinctive click (fig. A.4b). After correct assembly of ISOFIX fasteners (5) the indicator on the
button (15) will turn from red into green. Make sure indicators are green, it means the
installation is correct (fig. A.5).
• NOTE! Locking fasteners are correctly mounted only when both button indicators are fully
green.
• When the child safety seat has been properly installed with the use of ISOFIX fasteners (5),
set it in a forward-facing position. Press the seat rotation lever (12); (fig. A.6) to rotate the
safety seat to the forward-facing position (fig. A.7.1), a correctly secured position is indicated
by the green color by the seat rotation lever (12).
• After completing operations related to position of the child safety seat, set the child safety
seat backrest inclination by holding the seat inclination lever (11); (fig. A.8), the child safety
seat must be set in any position from „1" to „4" (fig. A.9.1).
•NOTE! Any change of backrest inclination while using the safety seat requires you to reset
the length of Top tether upper fixing belt.
• Place Top tether upper fixing belt (3) with a hook on the child safety seat headrest.
• Such child safety seat must be pushed against the car seat by pressing on both sides of the
safety seat towards the backrest so that the safety seat adheres to the car seat backrest as
much as possible (fig. A.10.2). After sliding the car seat for a child against the back seat, grasp
the integrated seat base and thus tighten the ISOFIX attachments with left-right movement
(Fig. A.10.3). By doing this you make sure that the car seat for a child is securely fastened (Fig.
A.10.4).
57