Kinderkraft XPEDITION Bedienungsanleitung Seite 56

5.1 How to install the child safety seat in a rear-facing position, for children from 0+/I weight
groups (up to 18kg) in ISOFIX fixing system and „Top tether" upper fixing belt.
IMPORTANT! The vehicle manual show's location of ISOFIX fixing points and upper fixing belt
as well as other important information on installing the safety seat in the car.
The user MUST read the vehicle manual.
• Before installing the child safety seat, please remove the guard from ISOFIX fasteners (if not
removed beforehand). To do so, slide ISOFIX release key (15), the system will release the
guard which must be removed (fig. A.2.1, A.2.2).
• The child safety seat must be placed on the car seat near the backrest.
• Please slide ISOFIX fasteners (5) to their maximum length by unlocking and holding the
sliding lever (16) (fig. A.3), and then pulling the fasteners out (fig. A.3.1). The operation must
be performed on both sides of the child safety seat.
• Attach ISOFIX guides to the seat connectors (fig. A.4a)
• Protruding ISOFIX fasteners must be connected to car seat fasteners until you can hear a
distinctive click (fig. A.4b). When the installation is correct, ISOFIX indicator on the button (15)
will turn from red into green. Verify correct installation, make sure the indicators are green
(fig. A.5).
•NOTE! Locking fasteners are properly attached only when both button indicators are fully
green.
• When the child safety seat is properly mounted with the use of ISOFIX fasteners, set it in a
rear-facing position. Press the seat rotation lever (12) (fig. A.6) and rotate the child safety seat
so that its position is rear-facing (fig. A.7). The position is correct when the green color shows
up by the seat rotation lever (12).
• After completing operations related to position of the child safety seat, set the child safety
seat backrest inclination. Hold the seat inclination lever (11) (fig. A.8) to set position „1" of
the safety seat – flat position (fig. A.9).
• Adjust the headrest to child's height (see point 4.1).
• Such child safety seat must be pushed against the car seat by pressing on both sides of the
safety seat towards the backrest, so that the child safety seat adheres to the car seat backrest
as much as possible (fig. A10). After sliding the car seat for a child against the back seat, grasp
the integrated seat base and thus tighten the ISOFIX attachments with left-right movement
(Fig. A.10.1). By doing this you make sure that the car seat for a child is securely fastened.
• Grasp the car seat and check that it is securely fastened with no slack. If it moves and the
ISOFIX attachments do not extend, repeat the previous steps, check that both ISOFIX
indicators are completely green.
• There is Top tether upper fixing belt (3) with a hook at the back of the safety seat. Please
press the button and pull the adjustment buckle (fig. A.11), release Top tether upper fixing to
the suitable length. Top tether must be placed in one of the guides (13) at the back of the
safety seat shell (fig. A.1.6, A.1.7).
NOTE! Please get familiar with correct path of Top tether upper fixing belt to keep the safety
seat rotation function (see point 4.5).
• Put the belt fixing hook on the car fixing point, as recommended in the car manual.
56