Balluff BTL7-Serie Betriebsanleitung Seite 38

BTL7-A/C/E/G_ _ _-M_ _ _ _-A/B/Y/Z(8)-S32/S115/S135/S140/KA_ _/FA_ _
Micropulse Transducer - Rod Style
3
Construction and function
Output signal with rising
characteristic:
BTL7-...-Cable
BTL7-...-S115
13.5
3)
Calibration device
1) Unusable area
2) Not included in scope of delivery
3) Not included in scope of delivery of
BTL7-...-S140
Version
...-A/B/Y/Z-...
...-A8/B8/Y8/Z8-...
Fig. 3-1: BTL7...A/B/Y/Z(8)... transducer, construction and function
3.1 Construction
Electrical connection: The electrical connection is made
via a cable or a connector (see Ordering code on
page 29).
BTL housing: Aluminum housing containing the
processing electronics.
Mounting thread: We recommend assembling this
transducer on the mounting thread:
– BTL7-...-A/B: M18×1.5
– BTL7-...-Y/Z: 3/4"-16UNF
The transducers with Ø 10.2 mm have an additional thread
at the end of the rod to support larger nominal lengths.
www.balluff.com
All manuals and user guides at all-guides.com
Error signal
100 %
0 %
Mounting surface
B: 30-1 mm
Z: 2"-0.04"
1)
BTL7-...-S32/S135
BTL7-...-S140
12.8
D1 G
10.2 mm Thread
M4x4/6 deep
8 mm No thread
Null point End point
Damping zone 1)
Nominal length =
Measuring range
Magnet 2)
Thread size:
B: M18x1.5
Z: 3/4"-16UNF
Mounting surface
A: 30-1 mm
Y: 2"-0.04"
1)
2)
Magnet: Defines the position to be measured on the
waveguide. Magnets are available in various models and
must be ordered separately (see accessories on
page 25).
Nominal length: Defines the available measuring range.
Rods with various nominal lengths from 25 mm to
7620 mm are available depending on the version:
– Ø 10.2 mm: Nominal length from 25 mm to 7620 mm
– Ø 8 mm: Nominal length from 25 mm to 1016 mm
Damping zone: Area at the end of the rod that cannot be
used for measurements, but which may be passed over.
Calibration device: Additional device for calibrating the
transducer (not for BTL7-....-S140).
Top view of the
BTL7-...-S32
Top view of the
BTL7-...-S140
Thread size:
A: M18x1.5
Y: 3/4"-16UNF
english
7