hanseatic SY-3288C1IR-E1-C64-L131-600 Gebrauchsanleitung Seite 44

Page EN-16 Assembly
(12) (11)
18. Screw two mounting rails (7) with four
screws each (10), four washers each (11)
and four nuts (12) in such a way that the
exhaust hood will later hang at the cor-
rect height.
Please note! The bracket for the moun-
ting rails on top of the motor housing are
approx. 28 cm above the lower edge
of the exhaust hood. Therefore, deduct
28 cm from the ceiling to the desired lo-
wer edge height of the exhaust hood.
(9)
19. As shown, screw the assembled moun-
ting rails (10) to the mounting rail bra-
cket (9) with four screws (7), four was-
hers (11) and four nuts (12).
(7) ( ( (10)
20. Place the two halves of the check valve
(26)
21. Only for exhaust air operation: Attach
(7)
(10)
(11)
(12)
22. As shown, screw the assembled moun-
Pins
into the opening on the top of the exhaust
hood. Make sure that the pins on the val-
ve are facing outwards.
(6)
the exhaust air hose (6) opening with a
diameter of 153 mm (see marking on the
hose) to the vent opening on the motor
housing in the exhaust hood (1) and se-
cure it with cable ties (26).
(7)
(9)
ting rails (10) and mounting rail bra-
(10)