Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page EN-14
Assembly
(21)
7. Remove the lower ring (21) from the
exhaust hood, leaving the metal ring (22)
on the upper edge of the housing as much
as possible.
(5)
) )
)
8. Place the glass pane (5) on the exhaust
hood (1).
9. If necessary, loosen the cable strap
around the LED light tube (16) and
connect the plug to a plug in the plug box
(18) (it must click into place).
(22)
10. Guide the LED light tube (16) through the
recess (23) of the metal ring on the upper
edge of the housing and insert it between
the glass pane (5) and the metal ring so
that the bright dotted side (the LEDs)
face outwards towards the glass pane
(5).
(18)
(19)
(20)
11. Place the lower ring (21) on the exhaust
hood (1). The cable feed-throughs (24) in
the lower ring (21) and the exhaust hood
(1) must lie on top of one another.
12. Screw the lower ring (21) with four
screws (19) and four washers (20) to the
exhaust hood (1).
(16)
(23)
(21)
(5)
Werbung
Kapitel
Inhaltsverzeichnis
