Connecting The Dishwasher To The Electricity; Substructure - hanseatic HG6085D14J7635EI Gebrauchsanleitung

Page EN-30 Set-up, connection and initial start-up
2. Check that the connection to the water
tap is sealed. Turn on the water tap slow-
ly and ensure that no water is escaping.
Then close the tap again.
Connecting the dishwasher to
the electricity
WARNING!
Risk of electric shock!
Faulty electrical installation or excessive
mains voltage may result in an electric
shock.
Prior to connecting the dishwasher,
■
ensure that you have taken note of all
the safety instructions and adhered
to them (see page EN-4).
Fire hazard!
Improper handling of the appliance
can lead to fi re.
■ Never use multi-socket adapters, mul-
ti-socket strips, travel adapters or the
like.
Depending on the recess into which the dish-
washer will be installed, the dishwasher should
be connected before or after installation.
– For the electrical connection of the dish-
washer, a professional must install an
earthed power socket with its own fuse of a
sufficient size (220–240 V~ / 50 Hz / 10 A).
– The plug must be installed in such a way
that the recess into which the dishwasher
will be fitted is deep enough even when the
plug is plugged in.
– Do not use a multi-socket extension cable,
multi-socket plug, travel adapter, extension
cable or similar.
– We recommend using a pulse-sensitive re-
sidual current device (RCD).
• Insert the mains plug into the socket.

Substructure

If you are setting up your dishwasher as a
freestanding appliance, continue with (see
"Water hardness" on page EN-32).
NOTICE
Risk of damage to property!
Selecting the wrong screws can dam-
age the worktop.
Select the correct screws with the ap-
■
propriate screw length.
Use the enclosed screws.
■
Requirements:
• Only install the dishwasher underneath a
continuous worktop which is joined to the
units adjacent to the dishwasher.
• Maintain sufficient distance from the walls
and adjacent appliances. The recess
dimensions must at least correspond to
the details in the diagram "Recess dimen-
sions" on the next page.
1. Remove cardboard, polystyrene and ad-
hesive strips from the inside of the dish-
washer, if you have not already done so.
2. Loosen both screws on the reverse side
of the covering panel and remove them.