Belden HIRSCHMANN RSPE Referenzhandbuch Seite 752

Tab. 58:
Byte Content
14 ACA removed
15 Not used
16 Not used
17 Connection
Tab. 59:
Byte Content
0 Report port error
1 Report connection error
2 Transmission rate too high
3 Port on
4 Link status
5 Bit rate
6 Duplex
7 Autonegotiation
UM Config RSPE
Release 9.0 12/2021
Gerätestatus
Access
ro
ro
Port-Status/Port-Parameter
Value Meaning
0 Unavailable
1 OK
2 The ACA has been removed.
0
1
2
0
1
2
0 Unavailable
1 OK
2 Connection failure
Access Value Meaning
rw 0 Do not send an alarm.
1 When one of the port alarm reasons
represented by bytes 4 .. 10 occurs,
send an alarm.
rw 0 Do not send an alarm.
1 Send alarm if the connection has failed.
rw 0 Do not send an alarm.
1 When the threshold values for the
transmission rate are exceed, send an
alarm.
rw 0 Unavailable
1 Port enabled
2 Port disabled
ro 0 Unavailable
1 Connection exists
2 Connection interrupted
ro 0 Unavailable
1 Unknown
2 10 MBit/s
2 100 MBit/s
2 1000 MBit/s
ro 0 Unavailable
1 Half duplex
2 Full duplex
ro 0 Unavailable
1 Disabled
2 Enabled
Industrieprotokolle
16.4 PROFINET
327