Belden HIRSCHMANN RSPE Referenzhandbuch Seite 730

Tab. 45:
Id Attribute
0x9 Mcast Config
0xA Selected Acd
0xB Last Conflict
Detected
Tab. 46:
Id Attribute
0x64 Cable Test
0x65 Cable Pair Size
0x66 Cable Test Result
UM Config RSPE
Release 9.0 12/2021
Attribute der Instanz 1 (Forts.)
Access
Rule
Get/Set STRUCT of:
Get/Set BOOL
Get
Hirschmann-Erweiterungen des TCP/IP-Interface-Objekts
Access
Rule
Set/Get STRUCT of:
Get
Get
Data type
USINT AllocControl
USINT reserved
UINT NumMcast
UDINT McastStartAddr
STRUCT of:
USINT AcdActivity
ARRAY of:
6 USINT RemoteMac
ARRAY of:
28 USINT ArpPdu
Data type
USINT Interface
USINT Status
USINT
STRUCT of:
USINT Interface
USINT CablePair
USINT CableStatus
USINT CableMin-
Length
USINT CableMax-
Length
USINTCableFailure-
Location
Industrieprotokolle
16.3 EtherNet/IP
Description
Alloc Control = 0
Number of IP multicast addresses
= 32
Multicast start address =
239.192.1.0
0=ACD disable
1=ACD enable (default)
ACD Diagnostic Parameters
Description
Interface
Status (1=Active, 2=Success,
3=Failure, 4=Uninitialized)
Size of the Cable Test Result
STRUCT of:
2 Pair for 100BASE
4 Pair for 1000BASE
100BASE:{
{Interface, CablePair1, CableS-
tatus, CableMinLength, CableMax-
Length, CableFailureLocation}
{Interface, CablePair2, CableS-
tatus, CableMinLength, CableMax-
Length, CableFailureLocation}
}
1000BASE:{
{Interface, CablePair1, CableS-
tatus, CableMinLength, CableMax-
Length, CableFailureLocation}
{Interface, CablePair2, CableS-
tatus, CableMinLength, CableMax-
Length, CableFailureLocation}
{Interface, CablePair3, CableS-
tatus, CableMinLength, CableMax-
Length, CableFailureLocation}
{Interface, CablePair4, CableS-
tatus, CableMinLength, CableMax-
Length, CableFailureLocation}
}
305