Ethernet-Link-Objekt - Belden HIRSCHMANN RSPE Referenzhandbuch

Industrieprotokolle
16.3 EtherNet/IP

Ethernet-Link-Objekt

Die Informationen in den folgenden Tabellen sind Teil des Ethernet-Link-Objekts. Um auf die Infor-
mationen zuzugreifen, verwenden Sie die folgenden Werte:
• Class(####)
• Instance(###)
• Attribute(#)
Legen Sie mindestens eine Instanz für das Gerät fest, zum Beispiel Instanz 1 als Instanz des CPU-
Ethernet-Interfaces (Class Code 0xF6) von EtherNet/IP.
Tab. 47:
Id Attribute
0x1 Interface Speed
0x2 Interface Flags
0x3 Physical Address
0x4 Interface Counters Get
0x5 Media Counters
306
Instanz-Attribute
Access
Rule
Get
Get
Get
Get
Data type Description
UDINT Used interface speed in MBit/s (10,
100, 1000, ...).
0 is used when the speed has not been
determined or is invalid because of
detected errors.
DWORD Interface Status Flags:
0:
1:
2:
3:
4:
5:
6:
ARRAY of: MAC address of physical interface
6 USINT
STRUCT of: InOctets, InUcastPackets, InNUcast-
Packets, InDiscards, InErrors, InUnk-
UDINT MibIICoun-
nownProtos, OutOctets,
ter1
OutUcastPackets, OutNUcastPa-
UDINT MibIICoun-
ckets, OutDiscards, OutErrors
ter2
...
STRUCT of: Alignment Errors, FCS Errors, Single
Collision, Multiple Collision, SQE Test
UDINT Ether-
Errors, Deferred Transmissions, Late
netMib Counter1
Collisions, Excessive Collisions, MAC
UDINT Ether-
TX Errors, Carrier Sense Errors, Frame
netMib Counter2
Too Long, MAC RX Errors
...
Link State (0=No link, 1=Link)
Duplex mode (0=Half, 1=Full)
Auto-Negotiation Status
0x0=Auto-Negotiation in progress
0x1=Auto-Negotiation failed
0x2=Failed but speed detected
0x3=Auto-Negotiation success
0x4=No Auto-Negotiation
Manual configuration require reset
(always 0 because it is not
needed)
Hardware error
UM Config RSPE
Release 9.0 12/2021