Belden HIRSCHMANN RSPE Referenzhandbuch Seite 739

Industrieprotokolle
16.3 EtherNet/IP
Tab. 51:
Id Attribute
0xB Aging Time
0xC Temperature C
0xD Temperature F
Device-Level-Ring-Objekt
Das DLR-Objekt (Device Level Ring) stellt die Schnittstelle für Konfigurations- und Statusinforma-
tionen für das DLR-Protokoll (Revision 2) bereit.
Ausschließlich Instanz 1 des TCP/IP Interface Object (Class Code 0x47) ist verfügbar.
Tab. 52:
Id Attribute
0x1 Network Topo-
logy
0x2 Network status
0x3 Ring Supervisor
Status
0x4 Ring Supervisor
Config
0x5 Ring Faults
Count
0x6 Last Active Node
on Port 1
314
Instanz-Attribute (Forts.)
Access
Rule
Get
Get
Get
(hardwareabhängig)
Class-Attribute
Access
Rule
Get
Get
1
Get
1
Set
1
Set
1
Get
Data type
UDINT
DINT
DINT
Data type
USINT
USINT
USINT
STRUCT of:
BOOL SupervisorE-
nable
USINT Supervisor-
Prece-dence
UDINT BeaconInterval
UDINT BeaconTimeout Default: 1960
UINT DlrVlanId
UINT
STRUCT of:
UDINT DeviceIp
ARRAY of:
6 USINT Mac
Description
Range 10..1000000 · 1/10 seconds
(default=300)
0=Learning off
Switch temperature in degrees
Celsius
Switch temperature in degrees
Fahrenheit
Description
0: Linear
1: Ring
Current status of the network.
0: normal
1: Ring Fault
2: Unexpected Loop Detection
3: Partial Network Fault
4: Rapid Fault/ Restore Cycle
0: Backup
1: Active Ring Supervisor
2: Normal Ring Node
3: Non-DLR topology
4: Device cannot support the
Beacon Interval or Timeout
Default: FALSE
Default: 0
Default: 400
Default: 0
Number of ring faults since power
up
Last Active node at the end of chain
through port 1 of active ring super-
visor during ring fault
UM Config RSPE
Release 9.0 12/2021