Required Tools; Prior To Installation - LIVARNO LUX LLES B2 Bedienungsanleitung Und Serviceinformationen

 Select the installation location so that the energy-saving outdoor spotlight is protected against wind,
rain and dirt.
 Find out in advance which installation material is suitable for the installation location you selected.
Suitable installation material for concrete is included with the energy-saving outdoor spotlight.

Required tools

The following tools are not supplied. This list can be used for orientation. The exact nature of the required
tools depends on the individual on-site conditions.
 Ladder
 Voltage tester
 Spirit level, folding ruler, pencil
 Drill with drill bits
 Phillips screwdriver, flat-bladed screwdriver
 Spanner, combination pliers, side cutter

Prior to installation

The installation must be performed only by an authorised electrician!
The circuit must be disconnected during the installation!
When drilling the holes, make sure that no cables or pipes in the wall are damaged.
 Before installation, familiarise yourself with the individual parts of the energy-saving outdoor spotlight
as well as the text and illustrations of these operating instructions and comply with them.
 Make sure that the cable to which the energy-saving outdoor spotlight is to be connected is not live.
To ensure that this is the case, remove the appropriate circuit fuse from your fuse box or switch the
fuse to the "0" position.
 Make sure that the cable is not live using a voltage tester!
LIVARNO LUX LLES B2
English - 9