EA01370D
11. Screw on the connection compartment cover.
12. Tighten the securing clamp of the connection compartment cover.
13. After connecting the sensor cable(s):
Connect the signal cable and the supply voltage cable .
6.2
Connecting the transmitter
1
Terminal connection for supply voltage
2
Terminal connection for signal transmission, input/output
3
Terminal connection for signal transmission, input/output or terminal connection for network
connection via service interface (CDI-RJ45); optional: connection for external WLAN antenna or
remote display and operating module DKX001
4
Protective earth (PE)
In addition to connecting the device via EtherNet/IP PROFINET and the available inputs/
outputs, additional connection options are also available:
• Integrate into a network via the service interface (CDI-RJ45) .
• Integrate the device into a ring topology .
6.2.1
Connecting the EtherNet/IP PROFINET connector
2.
1.
Loosen the securing clamp of the connection compartment cover.
2.
Unscrew the connection compartment cover.
3.
Squeeze the tabs of the display module holder together.
10
1
2
3
4
E S
C
–
+
E
3 mm
1.
3.
E S
C
–
+
E S
C
–
+
4.
E
3.
E
Endress+Hauser