Herunterladen Inhalt Inhalt Diese Seite drucken

Setting Up; Safety Information; Check Contents Of Pack; Connecting The Base Station - AUDIOLINE DECT6500B Bedienungsanleitung

Schnurloses digitales dect-telefon
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

3

Setting up

3.1

Safety Information

NOTE: Before setting up, it is essential that you read the safety information at the
beginning of this manual.
3.2

Check contents of pack

The following items are supplied:
one base station
one charger with power supply
two handsets with belt clips
one telephone connecting cable
3.3

Connecting the base station

Position the telephone near to your telephone connection socket and to a mains socket.
1.
Insert the plug of the power supply into the socket on the underside of the base
station and plug the power supply into a properly installed 230 V mains socket. The
plug-in power supply for the base station must always be connected. For safety
reasons, use only the plug-in mains power supply provided.
2.
Connect the telephone cable supplied to the telephone socket and the telephone
jack on the underside of the base station. Use only the new telephone cable
provided.
3.
Finally, run the two cables through the cable channels to the rear.
3.4

Connecting the charger

Set up the charger in the desired place within reach of a electricity supply socket.
3.5

Fitting/changing batteries

Open the battery compartment cover by sliding the cover
downwards and insert the new batteries. Take care to ensure that
the polarity is correct and close the battery compartment cover.
Use only rechargeable batteries, type AAA 2 x 1.2V, 750mAh.
Important note: Place the mobile unit on the base station with the display to
the front for at least 16 hours. The telephone may malfunction if the batteries
are not properly charged. The indicator light on the base station
illuminates when the mobile unit is charged.
3.6

Battery capacity

The rechargeable batteries for your telephone have a stand-by time of max. 120 hours
at room temperature and a maximum talk time of up to 8 hours.
The current battery capacity is shown in the display by means of the symbol
If the handset must be loaded again, you hear a warning tone. Place your phone on the
base unit or the charger for charging as soon as possible or it would turn off when it is
out of battery. When the mobile unit is correctly located on the base station or the
charger, you will hear a short tune in confirmation.
3.7

Setting the time

Before using the telephone, you should set the current time. You will find more
information in Chapter 7.1.
44
- Setting up -
one power supply base station
one instruction manual
four rechargeable batteries
always
.

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis