Receiving Calls; Making Calls; Handsfree Facility; Making An Internal Call - AUDIOLINE DECT6500B Bedienungsanleitung

4.3

Receiving calls

When a call arrives, the ring tone sounds on the mobile unit and on the base station. Lift
the mobile unit from the base station or press the call button
and the connection will be made.
If you do not want to be disturbed, press the SILENT display button and the ring tone for
this one call will be switched off directly.
The call indicator on the base station will flash during the call. To end the call, replace
the handset in the base station or press the
If it is not possible to accept a call because you are not there, a message will
appear in the display. In this way, you will be able to tell that you have received a
call during your absence. You will find further information on this topic in Chapter
4.10
4.4

Making calls

Enter the required telephone number with a maximum of 20 digits using the number
pad. The numbers pressed are shown in the display. Press the call button
the required connection will be made.
If you have entered a number incorrectly, you can delete the number by repeatedly
pressing the CLEAR button.
Note: You can also get a dialling tone by first pressing the call button
entering the digits of your required phone number, your telephone will dial the number
directly. With this method of making a call, it is not possible to correct individual digits in
the number in the manner described above.
4.5

Handsfree facility

If you want to use the hands-free facility, first set up the call in the usual way. During the
call, press the left display button twice (OPTIONS -> SPEAKER). You will now hear the
person you are speaking to over the loudspeaker in the mobile unit. By pressing the left
display button twice, you can change over between normal and handsfree mode during
a call. Always end calls made using the handsfree facility with the
4.6

Making an internal call

When you have connected multiple mobile units to a base station, you will be able to
make internal calls. To do this, press the
required mobile unit. You can also select the required mobile unit with the cursor and
make the connection with the OK display button. The call is accepted at the mobile unit
called with the call button
button.
Note:
If another mobile unit is already using the external line, an appropriate message will
appear in the display. In this case, it is not possible to make a further external call.
46
- Operation -
button on the mobile unit.
INT
button and the internal number of the
and terminated on both mobile units with the
on the mobile unit
and
. On
button .