Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
˜ Setting the desired
temperature
NOTES:
The temperature values are displayed in
degree Celsius (°C).
The target temperature
temperature
are shown in the display
[
]
Select a heating operating mode ( ,
) with
/
[
5 ]
[
Set the desired temperature
with
/
and
7 ]
[
[
]
As soon as the room temperature
the set target temperature
switches off automatically.
The product automatically switches back on
again as soon as the room temperature
falls below the set target temperature
active heating operation, the control lamp
is lit.
˜ Swivel function
The built-in swivel function allows the product to
swivel to the left and right. The air flow is thereby
evenly distributed in the room.
Turning the swivel function on/off:
Press
/
.
4 ]
[
[
]
When the swivel function is active,
shown in the display
˜ Timer
The timer turns off the product automatically after a
preset time elapses.
Setting the timer: During operation, press
/
.
3 ]
[
[
]
The hour display starts flashing.
Set the hours with
Press
/
to confirm.
3 ]
[
[
]
The minute display starts flashing.
Set the minutes with
and
/
.
9 ]
[
[
]
and the room
[
]
[
6 ]
or
.
]
[
]
/
.
9 ]
[
[
]
reaches
[
]
, the product
[
]
[
]
. In
[
]
[
is
[
]
.
6 ]
[
/
and
/
[
7 ]
[
]
9 ]
[
[
/
[
7 ]
[
]
Press
/
[
3 ]
5 seconds.
When the timer is set,
time
are shown in the display
[
]
After the set time runs down, the product turns
off automatically.
.
NOTE: When the product has been turned off
by the timer, End is shown in the display
If no button is pressed within 5 seconds
after
/
3 ]
[
will be aborted.
˜ Overheating protection
The product is equipped with overheating
protection, which automatically switches off the
fan and heating element in the event of internal
overheating. As soon as the product has cooled
]
down, the fan and the heating element are
switching on again automatically.
˜ Replacing the battery
Replace the remote control's
the signal reception weakens.
Follow the illustration on the back of the remote
control
.
[
]
Slightly press side lock of the battery
compartment
Remove the old battery.
Insert a new battery (type CR2025) with
correct polarity.
Push the battery compartment
˜ Transport
m
WARNING! Do not move the product while it
is in operation or cooling down.
.
]
Carry the product by the provided handle
only.
to confirm or wait for
[
]
and the remaining
[
6 ]
was pressed, the timer setting
[
]
battery as soon as
[
]
to pull it out (Fig. C).
[
]
shut.
[
]
.
.
6 ]
[
[
]
GB
15
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
