Switching The Fan Heater On And Off; Setting The Heat Level - Silvercrest SHLS 1800 A1 Bedienungsanleitung Und Sicherheitshinweise

9.1 Switching the fan heater on and off

•
Switch the On/Off switch (10) on. A beep sounds and the fan heater is in standby mode. The
fan heater can now be operated from the control panel (2) or the remote control.
•
To use the fan heater, press the
•
To switch the fan heater back to standby mode, press the
status indicator (6) goes out.
Please note that the fan heater has an auto power-off function. The fan continues running
for approx. 20 seconds until it completely switches off.
Please note that the fan heater swivels back to the centre position (horizontal/vertical)
when you switch it off.
Please note that the fan heater consumes minimal electricity when in standby mode.
•
In order to switch the fan heater off completely, it needs to be switched off from the On/Off
switch (10).
Even when the On/Off switch (10) is off, the full mains voltage is live in the device. Only
unplugging the mains plug disconnects the fan heater completely.

9.2 Setting the heat level

Every time you switch it on using the
settings.
To select a different mode, proceed as follows:
Press the button (15) or the
mode you want has been selected. The status indicator (6) shows the operating mode selected.
Indicator light (6)
Dark red
Light red
Blue
button (16 or 18). The status indicator (6) lights up.
button (16 or 18), the fan heater starts up using the last
button (20) as many times as necessary until the operating
High power: The fan heater works at 1800 W.
Low power: The fan heater works at 1200 W.
Fan function: In fan mode, the fan heater works without heating.
SilverCrest SHLS 1800 A1
button (16 or 18) again. The
Mode
English - 35