Operating; Using The Appliance For The First Time; Selecting The Temperature; Selecting Functions - Silvercrest SKHL 1800 A1 Bedienungsanleitung

RP66523 KeramikHL LB4 Seite 6 Dienstag, 24. Mai 2011 9:36 09
Note: The appliance consumes up to
9 amperes of current (1800 watts). If
you have plugged
consumers into the same circuit, check
that the maximum load for the installed
fuse is not exceeded, as otherwise the
fuse will trip.
5.1 Using the appliance for the first
time
Insert the mains plug into a wall socket that
complies with the technical data (see
"9. Technical data" on page 9).

5.2 Selecting functions

To select the available functions, turn the
function selector 1 to the relevant symbol.
II High heat setting
I Low heat setting
Fan without heater
0 Appliance is switched off
As soon as the appliance is working the
indicator light 5 comes on.
6
other power

5. Operating

5.3 Selecting the temperature

Set the required temperature with the
temperature selector 3 .
The heater switches off as soon as the room
reaches the required temperature.

5.4 Swivel function

The appliance has a swivel function.
This causes the appliance to swivel to and
fro, distributing the exiting air more evenly
through the room:
1. To switch the swivel function on, press
the swivel function button 2 .
2. To switch the swivel function off, press
the swivel function button 2 again.

5.5 Thermal cut-out

For your safety the appliance has a thermal
cut-out.
If the temperature inside the appliance
becomes too high, the appliance switches
off automatically:
1. Turn the function selector 1 to " 0" .
2. Check whether the air inlet or outlet is
obstructed and remove the cause.
If you cannot establish a cause and the
fault
appliance repaired or else take it out of
use.
occurs repeatedly, have the