System Time-Setting; Week Timer; Setting The Timer Programs 1-5 (Pre-Set Programs) - Silvercrest SKWH 2000 A2 Bedienungs- Und Sicherheitshinweise

7.6 System Time-Setting

Prior to use the week timer first time, set the
current time.
Please note: If necessary, the ceramic wall fan
heater must be disconnected from the power supply
before the system time settings can be adjusted.
Select the first heating level. The left sym-
bol lights up A on the display
For details, refer to Chapter setting of heating
levels.
Press the shown week timer button 9 :
Then the week day is shown on the display (see
the table). By pressing the plus 8 or minus 7
button, select the current day of the week:
01. Monday
03. Wednesday 04. Thursday
05. Friday
07. Sunday
Confirm your selection by pressing the OK
button 5 .
The display now shows the number of hours
(00). By pressing the plus 8 and minus 7
buttons, you can adjust the desired number of
hours (00-23).
Confirm your selection by pressing the OK
button 5 .
The display now shows the number of minutes
(00). By pressing the plus 8 and minus buttons
7 , you can adjust the desired number of min-
utes (00-59).
You can save your settings by pressing the OK
button 5 and then exit the menu.
As soon as you have set the system time, „P1"
appears in the display.
Wait 10 seconds without pressing any button. Then
the system settings will be accepted by the system.
The ambient temperature is shown on the display. If
necessary, you can continue selection of programs:
20 GB/IE/NI/CY/MT
02. Tuesday
06. Saturday
P1, P2... P6. For more information, see Chapter

'Week Timer".

Please note: To reset the system time, you have
to turn off the device and disconnect it from the
power supply.
7.7 Week Timer
Please note: It is not possible to start the week timer,
.
as long as the device is at the fan mode.
Please note: To adjust the week timer, you have to
set the system time first (see 'System Time-Setting').
The purpose of the week timer is to
automatically switch the wall-mounted
ceramic fan heater on and off at specific
times. To set the week timer, you have 5
pre-set programs available. Moreover,
you have also a program to be set manu-
ally. As soon as the function is activated,
the device automatically switches on or
off according to the respective time table.
7.8 Setting the timer programs 1-5
(pre-set programs)
Switch on the device (see Starting Up).
Select the first or the second heating level.
To do so, press the heating level button
The Symbol A lights up on the display. See
Chapter "setting of heating levels". Alternatively,
you can select a desired temperature (see chap-
ter "Temperature-Setting").
Please note: The wall-mounted ceramic fan heater
will be turned ON depending on the selected pro-
gram and run the last heating level or temperature
you selected.
.
11