Toshiba MML-AP0074NH-E Betriebsanleitung Seite 18

Q Dry operation
Start
PRESET
1
START/STOP button (
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select DRY .
3
Temperature button (
Set the desired temperature.
• The fan speed display indicates
• The OPERATION lamp (green) on the display
panel of the indoor unit lights, and operation starts
after approximately 3 minutes.
Stop
START/STOP button (
Press this button again to stop the air conditioner
NOTE
In the dry operation, airfl ow is blown out only from the
upper air outlet grille.
16-EN
1112750104.indb 16
3
FAN
TEMP
1
MODE
2
)
)
TEMP
.
)
Q Automatic operation (auto changeover)
This function is available only for use in combination with
a heat recovery model outdoor unit. If this function is
used with another model of outdoor unit, "A" (Auto)
appears on the remote controller but the automatic
operation is disabled.
Start
PRESET
1
START/STOP button (
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select A.
3
Temperature button (
Set the desired temperature.
4
Fan speed button (FAN)
Select one of
+
MED , MED
• The OPERATION lamp (green) on the display
panel of the indoor unit lights.
The operating mode is selected in accordance with
the room temperature and operation starts after
approximately 3 minutes.
• If the "A" mode is uncomfortable, you can select the
desired conditions manually.
Stop
START/STOP button (
Press this button again to stop the air conditioner.
– 16 –
Owner's Manual
3
FAN
4
TEMP
1
MODE
2
)
)
TEMP
LOW , LOW + ,
, HIGH .
)
12/8/2559 BE 5:07 PM