Philips Respironics BiliChek Benutzerhandbuch Seite 17

12
Connecting the Charger Base Ethernet Cable
The BiliChek unit can send data to your laboratory information
system if you have the necessary software. To allow this capability,
you must connect the ethernet cable included with your BiliChek
system.
1. Connect one end of the Ethernet cable into the connector on
the bottom of the charger base.
2. Connect the other end of the cable to your network
connection.
Charging the Hand-Held Unit Battery
Before initial use, the battery should be fully charged.
1. Place the BiliChek onto the charger base. A lightning bolt
icon will appear on the battery icon to indicate the battery is
charging.
2. Charge for eight hours or until the battery status icon on the
screen indicates a full charge.
BiliChek user manual
Connecting the Ethernet
Cable
Battery Status