Changing The Password; Device Name; Config; Erasing Service Data - axing MK 8-00 Betriebsanleitung

5.3.2.

Changing the password

The default password is: Ramsen8262.
The default password should be changed right after commissioning the headend.
è Type an new password with 8-10 characters (letters and/or digits).
è Re-enter the password.
è Click SAVE CHANGES to confirm and save the changes.
The saving of the password is confirmed.
5.3.3.

Device name

In the section DEVICE NAME you can set a new device name for the headend.
è Enter a name in the field SET NEW DEVICE NAME.
è Click on SAVE CHANGES.
The new device name is shown at the login.
5.4.

Config

5.4.1.

Erasing service data

In the section ERASE SERVICE DATA you can erase the settings from phase 2. The transponder data must be
read again for tuners 1-4 by executing a scan.
The headend is also set to remux mode.
è Click on erase.
The frontpage will be shown.
2021-08-01 | Technical improvements, changes in design, printing- and other errors reserved. 43