Installation; Ports On The Rear Panel; Power Supply - axing EoC 20-01 Betriebsanleitung

Operation Instructions | EoC 20-01 | Ethernet over Coax | Master

2. Installation

This chapter describes the installation of the EoC 20-01.

2.1. Ports on the rear panel

Port Name
Button
A DC IN 12V
B LAN2 (left)
C LAN2 (right)
D LAN1
E Reset
F EoC+RF
G RF
Note: LAN2 link could be connected either at SFP or RJ45 socket.

2.2. Power supply

The DC switch on the side has two positions:
DC IN: The EoC 20-01 runs in local power mode.
 Connect the power adapter to the DC IN 12V port and connect it to a wall outlet.
LINE: The EoC 20-01 runs in line power mode
 Powering EoC 20-01 via the coaxial cable connected to port 'RF+Data' or port 'RF' from coax is necessary
(typical 60 VAC input (range 48V~90V, 50/60 Hz AC).
 Alternatively powering EoC 20-01 via the port 'LAN2' Ethernet cabling (Power over Ethernet or PoE acc. to
IEEE 802.3af or 802.3at, it supports mode A and B).
8
Type Functions
DC Connect to the power adapter plug
SFP Connector for 100/1000Mbps SFP transceiver
RJ-45 100/1000 Base-T Gigabit Ethernet port, built-in PoE
PD function.
RJ-45 100/1000 Base-T Gigabit Ethernet port
– Reset button
F EoC port
F Connect to terrestrial antenna or CATV to feed in TV
signal. Otherwise terminate with CFA 8-00
2020-01-08 | Technical improvements, changes in design, printing- and other errors expected.