Cross Multiplex Mode - axing MK 8-00 Betriebsanleitung

Operation instructions | MK 8-00 | MK 16-00 | MK 8-06 | MK 16-06
4.2.2.

Cross Multiplex Mode

The cross multiplex mode is used:
·
To split the programs of a transonder to several modulators.
· To merge pogams of several transponders into one output channel.
Transmission capacities in the distribution networks can be optimized.
èChange the Network ID to a value greater than zero.
èClick on SAVE CHANGES.
The IDs of the transport streams TS ID1 to TS ID8[16] are automatically incremented by one to eight[16],
the cross multiplex mode is activated.
In the ONID field (Original Network ID), the network ID is taken by default. If necessary, the ONID can be
entered manually here.
Important:
If you use several MK in a network, then the network IDs must be the same and the network name should also
be the same. Transport stream IDs, on the other hand, may only be assigned once in the network.
24 2021-08-01 | Technical improvements, changes in design, printing- and other errors reserved.