Initial Use - Beurer IH25 Gebrauchsanweisung

5

Initial use

Setup
Remove the unit from the packaging. Pla-
ce it on a flat surface.
Ensure that the ventilation slits are free.
Before using the unit for the first time
Note:
Before first use, the atomiser and ac-
cessories should be cleaned and disin-
fected. See "Cleaning and sterilisation“",
page 26.
Attach the compressed air hose [15] at
the bottom of the atomiser [11].
Connect the other end of the hose [15]
to the hose connector [6] on the com-
pressor by lightly turning it.
Mains connection
Connect the unit only to the mains voltage
listed on the type plate.
Insert the mains cable plug [3] into a
suitable socket.
Push the plug completely into the mains
socket.
Note:
Ensure that there is a socket near to
where the unit will stand.
Lay the mains cable in such a way
that no one can trip over it.
To disconnect the compressor from
the mains after use, first switch off the
device and then remove the plug from
the socket.
23