Troubleshooting - Beurer IH25 Gebrauchsanweisung

10

Troubleshooting

Problem/Question
The nebuliser produces
little or no aerosol
Output is too low
Which medicines are suit-
able for inhalation?
Some inhalation solution
remains in the nebuliser.
What special steps should
be taken for babies and
children?
Inhalation with the mask
takes longer
Why do I need to replace
the nebuliser at regular
intervals?
Does each person need
their own nebuliser?
How often must the filter
be replaced?
How often should I steril-
ise the atomiser?
Possible Cause/Remedy
1. Too much or too little medicine in the atomiser.
Minimum: 0.5 ml, Maximum: 8 ml.
2. Check that the nozzle is not blocked
If necessary, clean the nozzles (e.g. by boiling).
Use the nebuliser again.
CAUTION: Only poke implements through the fine holes from the
underside of the nozzle.
3. The atomiser is not held in an upright position
4. The medicine solution is unsuitable for nebulising (e.g. too thick).
The medicine solution should be specified by the doctor.
Kinked hose, blocked filter, sealing cap (see p. 25) is closed, there is
too much inhalation solution
Consult your doctor.
Essentially all medicines that are suitable and approved for device-
based inhalation can be inhaled.
This is normal and occurs for technical reasons. Stop inhalation if
you hear a notable difference in the noise of the nebuliser.
1. When treating babies, the mask should cover the mouth and nose
to guarantee effective inhalation.
2. For children, the mask should also cover the mouth and nose.
Nebulisation next to a sleeping person is not suitable because in-
sufficient medicine reaches the lungs.
Note: Children should only use the device with help and under su-
pervision of an adult. Never leave a child alone with the nebuliser.
This is for technical reasons. Less medicine is inhaled per breath
through the mask holes than using the mouthpiece The aerosol is
mixed with ambient air through the holes in the mask.
There are two reasons for this:
1. To guarantee a therapeutically effective particle spectrum, the
nozzle holes should not exceed a certain diameter. Due to the
thermal and mechanical stresses, the plastic is subjected to a cer-
tain amount of wear. The nozzle attachment [13] is particularly
susceptible to this wear. This can also cause changes to the
droplet composition of the aerosol, which has a direct effect on
the effectiveness of the treatment.
2. You are also recommended to replace the nebuliser on a regular
basis for hygiene reasons.
This is absolutely necessary for hygiene reasons.
Check the filter regularly for contamination and replace it earlier if
necessary.
After the last use of each day (see Cleaning and sterilisation).
29