Initial Use; Use - Beurer FB 35 Gebrauchsanweisung

6. Initial use

• Remove the packaging
• Check the device, power supply and cables for damage.
• Before you plug in the foot spa, fill it up to the fill-level mark (approx 2-3 cm full) with either warm or cold
water. The foot rest should, however, be completely covered with water.
• Route the cable safely so that there is no risk of anyone tripping over it.
• Place the foot spa on a firm and level surface.

7. Use

Make yourself comfortable in a chair and place your feet on the foot rest and apply slight pressure. Never
stand up in the foot spa. The rubber feet on the base of the unit prevent it from sliding.
The device has two massage functions:
• Function 1 : bubble massage, infrared light and water temperature regulator
• Function 2 : activation of vibration massage
Bubble massage, infrared light and water temperature regulator
- Press the - button to switch on the bubble massage (with infrared light and water temperature regulator).
- Press the - button to switch the bubble massage (with infrared light and water temperature regulator)
off again.
These functions are only available together.
Optional vibration massage
While the bubble massage with infrared light and water temperature regulator is running, you have the option
to switch on the vibration massage. The vibration massage will only function when the bubble massage with
infrared light and water temperature regulator is switched on. It cannot be used separately.
- Press the - button to activate the vibration massage.
- Press the - button to switch the vibration massage off again.
Massage roller
You can experience a special massage effect by moving your feet back and forth on the 2 massage rollers
integrated into the bottom of the foot spa. The massage rollers can optionally be removed by pulling them
firmly upwards. When installing the rollers, make sure that the roller fixing points downwards, as shown in
the illustration.
Removable attachments
Place the chosen attachment onto the fixture provided. The brush attachment can be used to stimulate the
reflex zones in the soles of your feet. The massage attachment provides a soothing massage for your feet
and promotes the circulation. The corn and callus remover is used to remove dead skin cells and calluses.
Magnetic field and infrared light
The foot spa features 16 magnets and 4 infrared light dots which are integrated into the foot tub. They help
to boost circulation and stimulate reflexology points.
Removable aroma filter
The removable aroma filter allows you to easily add bath additives such as bath crystals, bath salts etc.
To do this, remove the filter cover [11] from the device by pulling it upwards. Remove the aroma filter [12].
Add bath products up to the level of the mark on the inside of the filter/underneath the first line of holes. Now
attach the filter underneath the filter cover. When doing so, note the arrow marks on the filter and foot spa; these
indicate the correct position of the filter. The two arrows must point to each other. Reattach the filter cover.
The filter can be easily removed and cleaned after use. Rinse the filter with clean water.
Please observe the fill-level mark on the filter and do not fill the filter above this mark.
Be aware that some spa products may create a great deal of foam when combined with the bubble massage.
For this reason, do not leave the foot spa unsupervised and switch it off immediately if excess foam builds up.
14