Adjustment Of The Antiskating - Clearaudio Universal Bedienungsanleitung

User manual / Bedienungsanleitung

5.6 Adjustment of the antiskating

In order to proceed the next adjustment, the previously removed antiskating screw needs to be
re-inserted.
Now you can adjust the antiskating by adjusting the screw (red box Pic. 18).
This adjustment depends on the tracking force of your cartridge:
Adjustment of the antiskating:
Minimal antiskating >
Middle antiskating
Maximum antiskating
Picture 1
(minimal antiskating)
Pic. 18: Antiskating adjustment
Before connecting the tonearm to your phono pre-amplifier, we recommend to re-check all settings
again and correct them if necessary.
We hope you enjoy your new
Your Clearaudio team
Page / Seite 16
tracking force
1.0 - 1.5g
> 1.5 - 2.0g
> 2.0g and higher
Picture 2
(Middle antiskating)
The tonearm adjustment is now complete.
Universal
tonearm.
Position of the antiskating screw
> see picture 1
> see picture 2
> see picture 3
Picture 3
(maximum antiskating)
(Screw completly inserted)
© clearaudio electronic GmbH, 2021-09