Mounting The Universal Tonearm Without Vta-Lifter; Adjustment Of The Distance Between Spindle And Pivot Point - Clearaudio Universal Bedienungsanleitung

User manual / Bedienungsanleitung
3. Mounting the
Pic. 9: Mounting the clamping ring without
VTA-Lifter

4. Adjustment of the distance between spindle and pivot point

For the exact setting of the tonearm pivot point, we recommend to use the Clearaudio alignment
gauge (Art. No. AC005/IEC, also available from www.analogshop.de).
Make sure that the distance between spindle and the pivot point of the tonearm is exactly 222mm
Universal
(for 9 inch) and 295mm (for
You can adjust the distance by rotating the tonearm base.
Please tighten the tonearm base and check the measurement again.
Pic. 10: Distance between spindle and tonearm pivot point
Page / Seite 10
Universal
tonearm without VTA-Lifter
Universal
Universal
9 inch
222mm
Universal
To assemble the
please follow the separate user manual for the VTA-
Lifter.
Take the clamping ring and place it on the recess in the
tonearm base.
Now you can attach the clamping ring to the tonearm
base with the 3 supplied M4 x 10 screws.
Make sure that the side hole of the clamping ring
(see Pic. 9) remains accessible.
Insert the tonearm cable first and then the tonearm foot
Universal
of the tonearm into the hole of the clamping
ring.
12 inch) (Pic. 10).
© clearaudio electronic GmbH, 2021-09
tonearm with VTA-Lifter,
Universal
12 inch
295mm