Mounting The Tonearm Base And Folding Base - Clearaudio TT3 Bedienungsanleitung

User manual / Bedienungsanleitung

2. Mounting the tonearm base and folding base

2.1 Mounting the tonearm base and folding base on a Clearaudio Performance DC or
Ovation turntable
Please check if the correct tonearm base is mounted on your turntable (Pic. 2).
Pic. 2: Tonearmbase for Performance
DC & Ovation (Art. No. AC031-3)
hex wrench #3 (Pic. 1, #3; page 5). Please make sure that the bases sit perfect on the turntable.
To mount the height adaptor with 14.5mm and 10mm you will need the M4 x 40 screws which are
already pre-mounted.
If you don't need the height adaptor, then use the M4 x 30 screws (Pic. 1, #5; page 5).
The height adaptor will be required depending on the dimensions of the turntable and cartridge.
Our dealer/distributor will help you or contact Clearaudio directly.
Now you can tighten all of the screws (see Pic. 4).
Pic. 3: Mounting the folding base
Pic. 4: Tightening the screws
Made in Germany
If not, place the turntable on the edge of a table or similar surface,
so you have access to the tonearm base from below. Remove the
previous tonearm base by loosening the six M4 x 35mm screws
with a hex wrench on the bottom side of the clamping ring.
Exchange the tonearm base for the correct one (see pic. 2) and
loosely tighten it so the tonearm base is still rotatable.
Now you can fit the folding base and the dedicated height-
adaptor with the screws provided (Pic. 1, #5; page 5), using the
Folding base
Height adaptor
Tonearm base
Page / Seite 7