Control Panel - Up & Down Button; System Initialisation / First Start-Up; Height Adjustment - Nowy Styl XIO 2.0 Original Bedienungsanleitung

7. Control panel functions: the up/down
adjustment button
7.1 System initialisation / First start-up
To ensure correct operation, the workstation base needs to be initialised before first use.
| Press and hold the "down" button until the workstation reaches its lowest position, then release the button.
The same function applies if the wires connecting the columns with the control module have been discon-
nected. If the control module is forcing initialisation, the workstation can only move "down" at slow speed.
Releasing the button too early may cause the workstation to malfunction. If this happens, the initialisation
procedure must be repeated.
7.2 Height adjustment
To decrease desk height:
| Press and hold the "down" button until the
desired height is reached.
The "down"/"up" movement of the desk will continue until you release the button or until the lowest/highest
possible position is reached.
On uneven floor, use glides to level the workstation before adjusting its height.
14 EN
Note: Use only the control module provided by the manufacturer for each specific
product type. The adjustment range limits have been set at the factory.
Danger: The anti-collision function is not active during an initialisation or reset proce-
dure. Please always be mindful of a potential risk of crushing during those procedures.
To increase desk height:
| Press and hold the "up" button until the desired
height is reached.