Reset; Control Panel - With Display And Memory Function; System Initialisation / First Start-Up - Nowy Styl XIO 2.0 Original Bedienungsanleitung

7.3 Reset
1. Press and hold both "down" and "up" buttons for at least 10 seconds or longer.
2. Proceed with system initialisation/first start-up procedure (7.1)
Releasing the buttons too early may cause the workstation to malfunction. If this happens,
the initialisation procedure must be repeated.
8. Control panel – with display and memory function
8.1 System initialisation / First start-up
To ensure correct operation, the workstation base needs to be initialised before first use.
| Press and hold the "down" button until the workstation reaches its lowest position, then release the button.
During the initialisation procedure, the symbol will be shown on the display.
The same function applies if the wires connecting the columns with the control module have been discon-
nected, or when a height setting error has occurred in an end position, or when the actual height is not
aligned with the height shown on the display. If the control module is forcing initialisation (symbol
on display), the workstation can only move "down" at slow speed.
Releasing the button too early may cause the workstation to malfunction. If this happens, the initialisation
procedure must be repeated.
EN 15