Error Messages On The Display - Nowy Styl XIO 2.0 Original Bedienungsanleitung

10.

Error messages on the display

Symbol on the display Description
Short circuit on DRIVE 1
Short circuit on DRIVE 2
Relay contact is sticking
The cable connecting DRIVE 1 is
disconnected
The cable connecting DRIVE 2 is
disconnected
No measurable movement
System protection / system stop. The
controller monitors operation time
and maximum temperature. One of
the two values has been exceeded.
Collision detected
Overload on DRIVE 1
Overload on DRIVE 2
Loss of DRIVE synchronisation
Loss of controller synchronisation
Anti- collision sensor error
Solution
Unplug the power supply. Check cables
connecting the column to the control module
for damage or connect the appropriate DRIVE
to the appropriate socket. If needed, perform
system initialisation / first start-up following
the user manual.
Replace the controller.
Check the connection of the cables connecting
the column to the control module and perform
a restart/first start-up.
Unplug the power supply. Check cables
connecting the column to the control module
for damage or connect the appropriate DRIVE
to the appropriate socket. If needed, perform
system initialisation / first start-up following
the user manual.
Wait for the control module to cool down and
the display to turn off.
The controller will allow movement for 20 s.
After a break of 18 minutes, the workstation
can be adjusted again constantly for maximum
2 minutes.
Remove the obstacle
Maximum load has been exceeded. Reduce the
load by removing extra items from the desk
top. Level the workstation
with glides. Perform system initialisation / first
start-up following the user manual.
Reduce the load by removing extra items from
the desk top- if applicable.
Level the workstation with glides. Perform
system initialisation / first start-up following
the user manual.
Check if the cables are properly connected to
the controller and the mains. Perform system
initialisation / first start-up following the user
manual.
Height adjustment is possible but without the
anti-collision system. Check the external an-
ti-collision sensor for connection to the control
module.
EN 25