Stihl FSA 130 R Gebrauchsanleitung Seite 33

6 Assembling the Trimmer
2
► Take out the screws (2).
► Pull off the deflector (1).
6.4 Fitting and Removing the Skirt
6.4.1 Fitting the Skirt
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
1
2
► Slide the guide slot in the skirt (2) onto the
deflector (1) – it must snap into position.
► Push the line limiting blade (3) into the slot in
the skirt (2).
► Insert and tighten down the screw (4) firmly.
6.4.2 Removing the Skirt
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
► Insert stop pin (2) into the hole in the skirt (1).
► Use the stop pin (2) to slide the skirt (1) off the
deflector.
The line limiting blade (1) can be left on the skirt.
0458-725-9621-C
1
3
4
2
1
6.5 Mounting and Removing the
Mowing Head
6.5.1 Mounting the Mowing Head
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
► Place the thrust plate (2) on the shaft (3) so
that its smaller diameter faces up.
► Fit the mowing head (1) on the shaft (3) and
turn it counterclockwise.
► Insert the stop pin (4) in the bore as far as
stop and hold it depressed.
► Rotate the mowing head (1) counterclockwise
until the stop pin (4) engages in position.
The shaft is now blocked.
► Tighten down the mowing head (1) firmly by
hand.
► Remove the stop pin (4).
6.5.2 Removing the Mowing Head
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
► Insert the stop pin in the bore as far as stop
and hold it depressed.
► Rotate the mowing head (3) until the stop pin
engages in position.
The shaft is now blocked.
► Unscrew the mowing head clockwise.
► Remove the thrust plate.
► Remove stop pin.
6.6 Removing and Installing Metal
Cutting Attachment
6.6.1 Mounting Metal Cutting Attachment
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
English
1
2
3
4
4
1
33