Sanremo CUBE V Gebrauchsanleitung Seite 46

CUBE
- Stand-by
After 30 minutes from the last dispensing, the
machine switches to the stand-by status making LED
1 blinking and turning off all the heating and level
regulation functions. 5 minutes before the activation
of this function, LEDs 1 and 2 start flashing
alternately to warn the user of the upcoming event.
To inhibit this feature for another 30 minutes, simply
activate the coffee lever or press the display button.
During the stand-by phase the display shows the
text "Stb" (see section 7.2 to disable this feature).
DEFAULT OFF.
- Scheduler
A scheduler to program the switching on in three
daily time slots can only be managed through
WebApp. If the scheduler is enabled, the DIGIT3 dot
will light up.
120.
7.2 ENABLING THE FUNCTIONS
To enter this menu proceed as follows with the
machine switched off:
• switch on the machine, wait for LED 1 to come
on, raise and lower the delivery lever twice
within the first 5 seconds.
• LED 1, LED 2 and LED 3, each corresponding
to a function, are switched on in sequence and
every 3 seconds:
• LED 1 corresponds to stand-by;
• LED 2 corresponds to the wifi module;
• LED 3 corresponds to the reset to the factory
parameters.
To select one of these functions, raise the lever when
the relevant LED is on.
7.2.a Enabling automatic stand-by
Wait for LED 1 to come on and raise the unit lever
within 3 seconds, LED 1 will stay on to confirm the
selection. If you leave the lever up it will enable
the function (the display shows the text "EOn"); if
you turn it down it will disable and turn off the LED
(the display shows the text "EoF"). To confirm the
selection, do not move the lever for 5 seconds.
Enabling WIFI module
Wait for LED 2 to come on and raise the unit lever
within 3 seconds, LED 2 will stay on to confirm the
selection. If you leave the lever up it will enable the
function (the display shows "rOn"); if you turn it
down it will disable and turn off the LED (the display
shows "rOF"). To confirm the selection, do not move
the lever for 5 seconds.
Resetting to factory parameters
7.2.c
a. Lift up the dispensing lever (switch contact
CLOSED) within 3 seconds after LED 3 comes
on to confirm the selection (keep the lever in the
dispensing position).
b. LED 3 remains steady on: this confirms
access to the menu.
c. To start the RESET procedure, lower the lever
(switch contact OPEN). If you do not lower the lever
within 120s the machine will automatically exit from
this menu without performing any reset.
d. LED 3 flashes 5 times 200ms ON and 200
ms OFF to confirm the operation in progress (the
version with display also shows the fixed message
"RST").
At the end, the machine automatically exits this
menu and switched to normal operating mode.
7.3 DISPLAY FUNCTIONS AND SPECIFICATIONS
A. Setting service boiler unit of measurement
Press and hold the button on the side of the display
for 6 seconds until "C" or "F" is displayed. Press the
button (flashing text) again to switch from "C" to "F"
or vice versa; wait 5 seconds without pressing any
buttons to confirm and exit;
B. Enabling water filter signal
With the machine switched off, switch it on by
pressing and holding the button on the side of
the display for 5 seconds until the word "FLT"
is displayed. Press the button within 5 seconds,
the message becomes "F.XX"; the value "XX"
indicates the months set, after which the message is
displayed. Press the button to change the value from
1 to 12 months (value 00 disables the function).
Wait 5 seconds without pressing any buttons to
confirm and exit;
46
Using the machine