Sanremo CUBE V Gebrauchsanleitung Seite 32

CUBE
BEFORE REMOVING ANY GUARD,
MAKE SURE THAT THE MAIN SWITCH IS
ON "OFF" (O) AND REMOVE THE PLUG
FROM THE OUTLET, SO THAT POWER
SUPPLY IS DISCONNECTED FROM THE
MACHINE DURING THE OPERATION.
- CHECK THAT ALL SAFETY DEVICES
(GUARDS, CASES, MICROSWITCHES,
ETC.) HAVE NOT BEEN TAMPERED
WITH AND ARE PERFECTLY
OPERATING. OTHERWISE, SERVICE
THEM.
- DO NOT REMOVE SAFETY DEVICES.
- TO AVOID PERSONAL RISKS, ONLY
USE SUITABLE TOOLS COMPLIANT
WITH NATIONAL SAFETY
STANDARDS.
- PAY UTMOST ATTENTION TO THE
WARNING LABELS ON THE MACHINE
EVERY TIME YOU OPERATE ON OR
NEAR IT.
- IN THE EVENT OF MACHINE
MALFUNCTION OR DAMAGE TO
COMPONENTS, CONTACT YOUR
DEALER OR THE MANUFACTURER.
- IT IS STRICTLY FORBIDDEN TO USE
THE MACHINE FOR A PURPOSE
OTHER THAN THE EXPECTED AND
DOCUMENTED PURPOSE.
- THE MANUFACTURER WILL NOT BE
HELD LIABLE FOR ANY ACCIDENT
TO PERSONS OR DAMAGE TO
PROPERTY ARISING FROM FAILURE
TO OBSERVE SAFETY STANDARDS
AND THE INSTRUCTIONS OF THIS
MANUAL. ANY USE OTHER THAN
THE USE DESCRIBED IN THIS MANUAL
MUST BE CONSIDERED AS MISUSE. IF
General rules and warnings
THIS MANUAL IS NOT SUFFICIENTLY
SUITABLE TO YOUR NEEDS, ALWAYS
CONTACT THE DEALER OR THE
MANUFACTURER TO RECEIVE FURTHER
INSTRUCTIONS AND SOLUTIONS.
- THESE SAFETY STANDARDS COMPLETE
OR INTEGRATE THE CURRENT LOCAL
SAFETY REGULATIONS.
- IN DOUBT, ALWAYS REQUEST THE
INTERVENTION OF SPECIALIZED
PERSONNEL.
- ELECTRICAL/ELECTRONIC OR
MECHANICAL TAMPERING WITH
THE MACHINE BY THE USER AND
NEGLIGENT USE OF THE MACHINE
WILL WAIVE ANY LIABILITY FOR THE
MANUFACTURER, MAKING THE USER
THE ONLY ONE RESPONSIBLE BEFORE
INJURY PREVENTION AUTHORITIES.
1.2 REFERENCES TO THE LEGISLATION
- THE MACHINE AND ITS
SAFETY DEVICES HAVE BEEN
MANUFACTURED IN COMPLIANCE
WITH THE STANDARDS LISTED IN THE
DECLARATION OF CONFORMITY.
32