Technical Data - LD Systems CURV 500 I AMP Bedienungsanleitung

TECHNICAL DATA

Model number:
Product type:
Type:
Rated output power (1 kHz @ 2,7 Ohm):
Rated output power (1 kHz @ 4 Ohm):
Rated output power (1 kHz @ 8 Ohm):
Rated output power (1 kHz @ 16 Ohm):
Rated power output BTL / 70 V operation
(Bridge Tied Load, 1 kHz @ 4 Ohm):
Output circuitry:
Frequency response +/- 1 dB:
THD:
Protection circuits:
Controls:
Indicators:
AD/DA converter sampling frequency:
AD/DA converter resolution:
Dynamic range:
Maximum delay / Channel:
Equalizer:
Line inputs:
Line input connectors:
Loudspeaker outputs:
Speaker output connections:
Ground Lift:
Cooling:
Operating voltage:
Fuse:
Power consumption @ full load:
Ambient temperature (in operation):
Relative humidity (in operation):
Width:
Height:
Depth:
Weight:
Features:
12
LDCURV500IAMP
DSP controlled amplifier
4-Channel
4 x 240 W (depending on preset)
4 x 240 W (depending on preset)
4 x 120 W (depending on preset)
4 x 60 W (depending on preset)
2 x 480 W (depending on preset)
Class D
10 Hz – 22000 Hz (depending on preset)
< 0,01 % @ 1 kHz (depending on preset)
Over-current, soft-start, DC, thermal overload, short circuit, multiband limiter
Push-turn-control
OLED display
48 kHz
24 Bit
114 dB
59 m/ 166 ms
10x parametric / channel
4
XLR (symmetrical), screw-/plug-in-terminals
4
Speakon compatible, screw-/plug-in-terminals
Yes, GUI integrated
Temperature controlled low-noise fan, noiseless in idle mode
100 – 240 V AC / 50 – 60 Hz
110 – 120 V AC: T10AL / 250 V
220 – 240 V AC: T5AL / 250 V
1100 W
0 °C – 35 °C
<80 % (non condensing)
482 mm
44 mm
420 mm
6.8 kg
4-channel DSP controlled, Purpose-designed for CURV500 installations, Smart 19"/ 1U housing, Each
channel can drive up to six CURV500 satellites or one CURV500ISUB subwoofer, Single push encoder
operation, High contrast OLED display, Temperature controlled low-noise fan, High efficiency switch
mode power supply (PFC)