clage DEX Next Gebrauchs- Und Montageanleitung Seite 26

DEX Next
3. How to use
EN
Value Description
Operation without load shedding
0
relay, factory setting
Operation with normal
1
load shedding relay
Operation with sensitive
2
load shedding relay
Operation Lock: Secure your settings with a four-digit PIN.
Note: The operation lock can only be deactivated with the correct PIN under
"Protected Sections" or under "Delete PIN". If you should forget your PIN, please
contact Customer Services.
PIN Entry: Use or to select digits from 00 to 99. To move to the next or previ-
ous digit, select or . Once you have selected both digits, confirm by
PIN must be reentered and confirmed by "OK" as a security measure.
If both entries match, you can access the section "Protected Sections".
Protected Sections: Select the areas for a PIN lock.
• Lock Settings: Automatically active as soon as a password has been generated.
Users can only access the settings menu with a PIN. Deactivating it deletes the cur-
rent PIN.
• + Lock Main Menu: Users can only access the main menu with a PIN
• + Lock Temperature: The outlet temperature is set to the current value and can only
be changed with a PIN. User profiles and applications can also only be changed with
a PIN.
Electricity price (currency/kWh): Specify the electricity price of your own electricity
supplier.
Water price (currency/m³): Specify the water price of your own water supplier.
Load Shedding: If further three-phase appliances are connected, a load shedding relay
designed for electronic instantaneous water heaters (CLAGE no. 82250) can be con-
nected to phase conductor L2. This relay ensures the operation of the water heater by
switching off other consumers until the end of heating operation.
Select "OK" to activate the edit mode. To set a value of "0", "1" or "2" press and hold
or for two seconds.
Operating mode 1 must be selected first, thus to check the correct operation of the
load shedding relay at low appliance output (35 degree celsius setpoint and low water
flow rate). Mode 2 must be selected if the load shedding relay flickers.
Factory Settings: All factory settings can be recalled. Temperature limit for showering
and load shedding are not affected.
Note: All customised user profiles and power and water prices entered, are deleted.
Delete Statistics: Use this function to delete all previously collected statistical data.
Deleted statistical data cannot be restored.
26
. The