Spare Parts Order - Scheppach 5906225901 Originalbetriebsanleitung

Petrol filter (Fig 8+9)
Note: The petrol filter (22) is a filter bowl located directly
under the petrol cap (2) , filtering any petrol added.
1. Turn the on /o ff switch (10) to the "OFF" position.
2. Open the petrol cap (2)
3. Remove the petrol filter (22) and clean in a non-
flammable solvent or solvent with a high flash
point.
4. Reinsert petrol filter (22).
5. Close the petrol cap (2).
Changing the oil (Fig. 5)
If the petrol engine operates frequently under high
temperatures or high loads, change the oil every 25
hours.
Changing the oil should take place when the engine
is warm.
WARNING! Drain fuel before replacing the oil.
Only use engine oil (15W-40).
• Always set up the device on a level and stable
surface. Do not operate the generator on forest
soil, which radiates heat during operation and in
the cooling phase and can ignite flammable ma-
terials!
• Remove the screws and the cover (5).
• Open the oil filler cap (17) and drain the warm
engine oil into a container by tilting the generator.
• Pour in engine oil (approx. 0.28 litres).
• Close the cover (5) and tighten the screws.
Low oil switch off
The low oil switch-off responds, if there is not enough
engine oil. The oil check bulb (12) starts to flash when
there is insufficient oil in the motor. The check bulb
begins to flash when the oil amount has gone below
the safe level. The engine will turn off independently
after a short time. Restart is possible only after pour-
ing in more engine oil.
10. Storage
Preparation for storage
• Empty the petrol tank with a petrol suc-
tion pump. Remove fuel filter and drain the
carburettor.Loosen the screw on the lower
side of the carburettor and drain the petrol
into a receptacle provided for this purpose..
Warning notice: Do not remove fuel in closed
rooms, close to fire or whilst smoking. Vapours
can cause explosions or fires.
• Start the engine and leave it running until the rest
of the petrol has been used up.
• Store fuel in tanks specifically designed for this
purpose.
• Change the oil after each season. To do this, re-
move the old oil from the warm engine and refill
with new oil.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
• Remove the spark plug. Fill about 20 ml of oil into
the cylinder using an oil can.
• Slowly pull the express start so that the oil pro-
tects the cylinder from the inside.
• Screw the spark plug back in
• Store the device in a well ventilated place or area.
11. Transport
Preparation for transporting
• Empty the petrol tank with a petrol suction pump
or alternatively using the petrol tap and a suitable
canister.
• Once it is ready for use, leave the engine running
until the rest of the petrol has been used up.
• Empty the engine oil from the engine (as de-
scribed).
• Remove the spark plug connector (16) from the
spark plug.
• Secure the device with a tension belt to prevent it
slipping out of place.
• The generator can be lifted and carried by using
the handle.

12. Spare parts order

Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the follow-
ing parts are therefore also required for use as con-
sumables.
Wear parts*: spark plug
* Not necessarily included in the scope of delivery!
13. Disposal
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types of
material, such as metal and plastic. Defective compo-
nents must be disposed of as special waste. Ask your
dealer or your local council.
GB | 23