Storage And Disposal; Storage Conditions; Disposal Of Oils And Process Condensate - Comprag A Serie Bedienungsanleitung

The compressor is overheating.
The safety-relief valve of the
separator tank is activated.

7. Storage and disposal

7.1 Storage conditions

The compressor should be kept at a temperature between -20° and +35°С with max. 85%
relative humidity.

7.2. Disposal of oils and process condensate.

Used oils, greasy filters and separators should be recycled in a sealed container and dis-
posed of at a local recycling or disposal facility. Do not allow precipitation to mix with oil.
Process condensate contains oil. Local environmental regulations govern the degree of
contamination of condensate discharge into sewers. Use process condensate separators to
separate oil and further impurities from condensate. Replaceable components of a process
condensate separator should be disposed of in the same way as greasy wiping cloths.
COMPRAG Schraubenkompressoren A-Serie
There's insufficient ventilation in
the facility where the compres-
sor is installed.
The oil level is too low.
The radiator is dirty.
The separator is dirty.
The pressure is too high (over13
bar).
Increase the air circulation
inside the facility.
Top up oil.
Blow down the radiator with
compressed air.
Perform maintenance by replac-
ing the separator.
Set the working pressure below
13 bar.
39