Rgbs / Ypbpr Picture Menu; Horizontal Position; Vertical Position - Nds surgical imaging ENDOVUE 42 Benutzerhandbuch

VGA / RGBS Picture Menu
YPbPr Picture Menu

Horizontal Position

Moves the image to the left or right. Press fi or fl to horizontally center the image.

Vertical Position

Moves the image up or down. Press fi or fl to vertically center the image.
Sharpness
Press fi or fl to adjust the sharpness (focus) of the displayed image. Note: When the VGA input is active
Sharpness cannot be adjusted when the display is operating at native resolution.
Phase
Press fi or fl to adjust the phase of the display's pixel clock.
Frequency
Adjusts the frequency of the display's pixel clock. With Scaling set to Fill adjust until image just fills the
screen horizontally. Press fi or fl to adjust the frequency of the display's pixel clock.
Overscan (Video)
This parameter is enabled when the input is video (camera) data.
0 = The image is displayed at a size that fills the screen without losing any video information. The image
presented to the display may include black bars top and bottom or left and right.
1, 2, 3, 4, 5 or 6 = The image is linearly enlarged, while remaining centered, in incremental steps. As the
image becomes larger video information will be lost from the top and bottom and / or left and right.
Select using fi or fl buttons.
Scaling (Graphics)
This parameter is enabled when the input is graphics (computer) data.
Fill = Expands the video image to fill the entire screen. The aspect ratio may not be accurately displayed.
Aspect = Expands the video image until its largest dimension fills the screen. Image may be displayed with
black bars on the top and bottom or the left and right. 1:1 = Displays the video data in its native size and
aspect ratio. Image may be displayed with black bars on the top and bottom and on the left and right.
Select using fi or fl buttons.
SmartSync / Alternate Modes
On initialization NDS' proprietary SmartSync technology examines the incoming signal and automatically
displays the video image in its proper format. To run SmartSync select the SmartSync / Alternate Modes
parameter and press the fi button. An Alternate Mode may be selected by pressing the fl button.
The Alternate Mode (format) parameter has two arguments X and Y. The left (X) argument is the current
mode and the right (Y) is the number of modes available. The mode (format) and / or Frequency changes
each time the fl button is pressed. When the mode count reaches its maximum the next fl button press
returns the mode count to 1.
7