Maintenance; Cleaning The Filter - Carrier XCT7 Installations- Und Benutzerhandbuch

Maintenance

• Repair can only be performed by professional personnel.
• Before touching the connection line, all power supplies should be switched off. Only after switching off the power
supply can the operator clean the air conditioner so as to avoid electric shock or injury.
• When cleaning the filter, make sure to use a stable platform; do not flush the air conditioner with water, or electric
shock might be caused.
Routine Maintainence:
Clean the filter and the air inlet grid.
• Do not dismantle the air indoor unit while running, faults or injury could occur.
• When the air conditioner operates in an environment with too much dust, clean the filter regularly (generally once every two
weeks).
1. Remove the air inlet grid as shown in the figure: press down the two locks on the grid (as shown in Fig. 1) to move it close to the
nearby grid, then gently lift it 45 degrees (as shown in Fig. 2), and then remove the air inlet grid.
2. Dismantle the gauze: press the outer frame of the air inlet grid with the thumb, draw the base angle of the gauze with the
forefinger, pull it out so as to make the gauze disengage from the locks, and then dismantle the gauze (as shown in Fig. 3).
1.
press down the locks
Fig. 1

Cleaning the Filter

• Cleaning
Clean the air cleaner with a vacuum cleaner or water to remove dust.
If there is too much dust, use the fan or directly spray the special cookware detergent on the air inlet grid, and then clean it with
water after 10 minutes.
(A) remove dust with a vacuum cleaner.
(B) for excessive dust, use a soft-hair brush and a mild detergent to clean.
(C) Allow filter to dry fully before reinstalling.
• Do not clean with hot water of over 50°C to avoid fading or distortion.
• Do not dry on the fire, or the cleaner might cause fire.
Attention
remove air inlet grid
Fig. 2
Attention
11
lock device
bottom of gauze
lock port
locks
lock device
frame of air inlet grid
Fig. 3