Inserting A Cd; Ejecting A Cd; Connecting/Removing A Usb Data Carrier; Selecting Tracks - Blaupunkt Toronto 400 BT Bedienungs- Und Einbauanleitung

• If the connected CD changer fi rst acquires
the inserted CDs (e.g. after an interruption
of the power supply or a change of the mag-
azine), "MAG SCAN" is displayed. If the CD
changer does not contain any CDs or maga-
zine, "NO DISC" is displayed.

Inserting a CD

Note:
You must not hinder or assist the drive as it
automatically draws in the CD.
Insert the CD with its printed side up into the
u
CD tray 7 until you feel a slight resistance.
The CD is automatically pulled in and its data
are checked (the display shows "READING"
during this time). Afterwards, the playback
starts in CD or MP3 mode. If a CD is inserted,
the display shows the CD symbol.
Note:
If the inserted CD cannot be played back, "CD
ERROR" is briefl y displayed and the CD is au-
tomatically ejected after approx. 2 seconds.

Ejecting a CD

Notes:
• If a CD is ejected and not removed, the
drive will automatically draw it back in
again after approx. 10 seconds.
• You can also eject CDs while the car sound
system is switched off or whilst another au-
dio source is activated.
button : to eject an inserted
Press the
u
CD.
02_Toronto400BT_gb.indd 37
CD/MP3/WMA/C'n'C/CD changer mode
Connecting/removing a USB data
carrier
To be able to connect a USB data carrier, the sup-
plied USB cable must be connected to the car
sound system (see Installation Instructions).
Switch of the car sound system so that the
u
data carrier will be correctly registered and
unregistered.
Connect the USB data carrier to the USB
u
cable or pull it off.
If a USB data carrier is connected, the display
shows the USB symbol. If the USB data car-
rier is initially selected as audio source after
connecting it or after switching on the car
sound system, the data are read in fi rst (the
display shows "READING" during this time).
Notes:
• If the connected USB data carrier cannot be
seen, "USB ERROR" is briefl y displayed.
• The time required for reading in the data
depends on the design and size of the USB
data carrier.

Selecting tracks

Briefl y press the button
u
change to the previous/next track.
Note:
If the current track plays longer than 3 sec-
5 once restarts the track.
onds, pressing
Select a folder/CD (only in MP3/
WMA/C'n'C or CD changer mode)
@ /
Press the button
u
the previous/next folder or CD.
Note:
This also allows you to change between
playlists of a device connected via C'n'C.
5 / > to
2 to change to
37
03.03.2009 13:22:28 Uhr