Inserting/Ejecting A Cd; Connecting/Removing A Usb Data Carrier - Blaupunkt Concept Pro II Bedienungs- Und Einbauanleitung

CD/MP3/WMA mode
Notes:
• The respective audio source can be se-
lected only if a corresponding data carrier
is inserted or a corresponding device is
connected.
• If the car sound system fi rst has to read
the data of a connected device or data car-
rier before the playback, the display shows
"READING". The duration of the reading
depends on the data volume and design of
the device or data carrier. If the device or
data carrier is defective or the transferred
data cannot be played back, a correspond-
ing message appears on the display (e. g.
"USB ERROR").

Inserting/ejecting a CD

Inserting a CD
Risk of severe damage to the CD
drive!
Noncircular contoured CDs (shape CDs)
and CDs with a diameter of 8 cm (mini CDs) must
not be used.
We accept no responsibility for any damage to the
CD drive that may occur as a result of the use of
unsuitable CDs.
Note:
You must not hinder or assist the drive as it
automatically draws in the CD.
u Insert the CD with its printed side up into the
5
CD tray until you feel a slight resistance.
The drive automatically draws in the CD and
checks its data. Afterwards, the playback
starts in CD or MP3 mode.
Note:
If the inserted CD cannot be played back, "CD
ERROR" is briefl y displayed and the CD is au-
tomatically ejected after approx. 2 seconds.
34
Ejecting a CD
Note:
You must not hinder or assist the drive as it
ejects the CD.
u Press the
button
CD.
Notes:
• If a CD is ejected and not removed, the
drive will automatically draw it back in
again after approx. 10 seconds.
• You can also eject CDs while the car sound
system is switched off or whilst another au-
dio source is activated.
Connecting/removing a USB data
carrier
Connecting a USB data carrier
u Switch off the car sound system so that the
data carrier will be correctly registered.
u Pull the protective cap of the USB socket
to the front until it moves out of the socket
and fold it down.
u Connect the USB data carrier.
u Turn on the car sound system.
If the USB data carrier is initially selected as
audio source, the data are read fi rst.
Notes:
• If the connected USB data carrier cannot
be seen, "USB ERROR" is briefl y displayed.
• The time required for reading in the data
depends on the design and size of the USB
data carrier.
Removing a USB data carrier
u Switch off the car sound system so that the
data carrier will be correctly unregistered.
u Disconnect the USB data carrier.
u Close the protective cap of the USB socket
9
to eject an inserted
:
:
.