Checchi & Magli TEXDRIVE BEST Bedienungs- Und Wartungsanleitung Seite 88

Proceed as outlined below.
Lift the work vehicle off the ground.
1) Loosen the wing nut (A).
2) Turn the lock lever (B).
3) Push the share forwards and turn it so it is facing
downwards.
Tyre check
Check the tyres for wear and if they feature tears or signs
of ageing, they must be replaced.
Check and if necessary restore the tyre pressure (see the
"Technical characteristics" table).
Cleaning the work vehicle
Clean the work vehicle with a high-pressure water jet
and, if necessary, with approved detergents.
The liquid used for washing could be hazardous for the
environment due to the presence of pollutants such as
detergents, oils, etc., therefore do not simply dump the
Troubleshooting
The following list contains a number of common problems that may arise during work, together with the ways to
solve them.
Problem
The seedling planted is too close
to the surface or too deep
The soil has not been properly
compacted on top of the seedlings
The seedling is planted at an angle
The seedling is lying overturned
on the ground
English language
MAINTENANCE INFORMATION
4) Clean the ploughshare with the tool provided (C).
5) Once the cleaning is complete, replace the plough-
share in the working position.
6) Check that the Plant Control device (D) is inside the
share.
7) Tighten the wing nut (A).
The pressure must be checked with the weight of the
work vehicle entirely on the ground and with nothing
and nobody on the work vehicle.
wastewater; dispose of it in suitable areas equipped with
separation devices for the pollutants.
Dry with compressed air and lubricate the components
shown (see "Lubrication diagram").
Likely cause
Incorrect planting depth
The dispenser is not synchronised
with the ejector
The packing wheels are not
properly adjusted
The dispenser is not synchronised
with the ejector
The Plant Control device is not in
the right position
The Plant Control device is not in
the right position
38
Solution
Make the relative adjustment (see
"Adjusting the planting depth")
Adjust the timing (see "Adjusting the
dispensing/ejection timing")
Adjust the packing wheels (see
"Adjusting the spacing between the
packing wheels and the ploughshare")
Adjust the timing (see "Adjusting the
dispensing/ejection timing")
Adjust the Plant Control device (see
"Adjusting the Plant Control")
Fit the Plant Control device inside the
ploughshare
7
Use and maintenance