Checchi & Magli TEXDRIVE BEST Bedienungs- Und Wartungsanleitung Seite 85

Transporting the work vehicle
Danger - Warning
For work vehicle loading/unloading, use lifting
equipment with a suitable capacity for the load to be
lifted.
Use all possible caution when lifting to avoid damag-
ing the work vehicle and causing injuries to persons
involved in operations.
Strap up the unit at the lifting points envisaged by the
manufacturer.
See the strap-up points and lifting procedures in the sec-
tions titled "Lifting (TEXDRIVE BEST)" on page 16 or "Lift-
ing (TEXDRIVE BEST DT)" on page 17.
Anchor the work unit to the means of transport with
ropes and secure the wheels with wedges.
UN41-0437AM
Proceed as outlined below.
1) Start the tractor and lift the work vehicle as far off the
ground as is permitted.
2) Get into the means of transport from the tractor's
driving seat.
3) Lower the work vehicle onto the truck bed.
English language
INFORMATION FOR USE
Units which are narrower than the maximum width al-
lowed by the Highway Code can be loaded , coupled to
the tractor, onto suitable means of transport using load-
ing ramps.
Danger - Warning
Thoroughly clean the ramps and loading platform
before boarding the vehicle.
Position the ramps on the transport means and fix
them in a stable way to the truck bed using the fas-
tening devices (pins, screws, chain etc.).
Where the ramps meet the truck bed there is a dan-
gerous bump so move the machine very carefully
over this point.
The figure shows how to load the work vehicle coupled
to the tractor onto the transport means.
4) Off the tractor engine and engage the parking
brake.
5) Anchor the work unit -tractor assembly to the means
of transport with ropes and secure the wheels with
wedges.
6) Before transporting, affix the relative signalling signs
to any parts jutting out from the means of transport.
35
6
Use and maintenance