Checchi & Magli TEXDRIVE BEST Bedienungs- Und Wartungsanleitung Seite 74

B
UN41-0431AM
For adjustments, proceed as outlined below.
1) Lift the work vehicle slightly off the ground.
2) Loosen the nuts (A).
3) Loosen the screws (B).
4) Slide the planting unit along the frame (D) until the
required plating spacing is obtained.
Adjusting the plant spacing
The gap between one plant and the next depends on
the number of teeth on the pinions installed.
A series of pinions may be fitted to ensure the required
plant spacing is obtained.
STANDARD EQUIPMENT PACKAGE 14 - 50
Plant spacing
cm inches
14 5 - 1/2
17 6 - 3/4
20 7 - 7/8
23 9 - 1/16
26 10 - 1/4
28 11
31 12 - 3/8
34 13 - 3/8
37 14 - 5/8
40 15 - 3/4
45 17 - 3/4
50 19 - 3/4
English language
ADJUSTMENT INFORMATION
A
D
N. teeth on the pinions
z 1 z 2
28
26
22
14
19
17
16
20
19
17
20
16
14
13
10 - 12
C
5) Tighten the screws (B).
6) Tighten the nuts (A).
7) Adjust the planting units so that the seedlings are
kept (C) cm 10 - 12 away from tractor wheel.
When replacing the pinions, the replacement must be
carried out on both driving wheels.
The charts state the possible distances between one
seedling and the next according to the pinions fitted.
z 2
UN41-0456AM
24
10 - 12 10 - 12
10 - 12
C C
cm cm cm
z 1
Use and maintenance
5
C
cm