Checchi & Magli SP 140 Bedienungs- Und Wartungsanleitung Seite 61

Carry out the operations described.
1)
Loosen the screws (A).
2)
Unscrew the screw (B).
3)
Remove the fixed guard (C).
4)
Loosen the sprocket (D).
5)
Remove the chain (E).
NOTICE
Fit the chain with the joining link positioned as
shown in the figure.
Replacing the cutting disc
Carry out the operations described.
1)
Lift the cutting disc off the ground (see "Adjusting
the cutting disc").
CAUTION
Make sure that the disc does not fall to the ground
unexpectedly as this could cause injury to the opera-
tor.
2)
Unscrew the nuts (A).
3)
Remove the screws (B).
4) Remove the cutting disc.
5) Position the new cutting disc.
6) Insert the screws (B).
7) Tighten the nuts (A).
8) Repeat the same procedure to replace the other
cutting disc.
Replacing ploughshare blades
Carry out the operations described.
1) Undo the screws (A).
2) Remove the blade (B).
3) Position the new blade.
4) Tighten the screws (A).
5) Repeat the same procedure to replace the other
blades.
English language
INFORMATION CONCERNING REPLACEMENTS
6)
7)
8)
9)
10) Tighten the screws (A).
UN41-0762CP
UN41-0763CP
27
Fit a new chain.
Tension the drive chain (see "Adjusting the trans-
mission chain tension").
Put the fixed guard (C) back in place.
Tighten the screw (B).
A
A B
8
B
Use and maintenance