Troubleshooting Guide - Kenwood kMix KMX75 Bedienungsanleitungen

Troubleshooting Guide

Problem
The whisk or K-beater
knocks against the
bottom of the bowl
or not reaching the
ingredients in the
bottom of the bowl.
'Mixer ready indicator
light' flashing when
Stand mixer first
plugged in.
The Stand mixer stops
during operation.
'Mixer ready indicator
light' flashing rapidly.
'Mixer ready indicator
light' flashing slowly
whilst machine plugged
in.
Cause
Tool at the wrong height
and needs adjusting.
Speed control not in the
'O' position.
Overload protection
or overheat system
activated.
Maximum capacity
exceeded.
Stand mixer has been left
plugged in for more than
30 minutes without being
operated and has gone
into Standby mode.
13
Solution
Adjust the height using a
suitable spanner – see "Tool
Adjustment" section.
Check and turn speed control to
the 'O' position.
Unplug and check for
obstruction or overloading.
Turn the speed control to "O"
and then restart.
If the machine will not operate,
remove some of the ingredients
to reduce the load and restart.
If this still does not resolve the
problem, unplug and allow to
stand for 15 minutes. Plug in and
reselect the speed.
If the machine does not restart
following the above procedure
contact "Customer care" for
further advice.
Turn the speed control to 'min'
then return to 'O' to reset the
machine.